Hidden Leak Calculator for Cedar Park, TX Water Damage
Compare an old water bill with the current one and run a simple meter test to see whether a hidden leak, often under the slab, is likely.
How to run the meter test
Turn off every faucet, the ice maker, the irrigation controller and anything else that uses water. Note the numbers on the meter at the curb box, wait 30 minutes, and read it again. If the dial or the low-flow indicator moved, water is leaving a pressurized pipe somewhere between the meter and the fixtures.
In a Cedar Park slab home that often means a slab leak, especially on the hot-water side. A plumber locates and repairs or reroutes the line, and the restoration team maps and dries whatever flooring, baseboard and slab surface the water reached. If the meter is still and the bill is high, check toilets and irrigation first.
Planning figures only. The tool is not a quote, an inspection or insurance advice. A firm number follows an on-site moisture assessment.
Hidden Leak Calculator questions
How much water can a slab leak waste?
A small pinhole can run a few dozen gallons a day, and a failed fitting can run hundreds. Because the water goes into the soil or up through the floor, a rising bill is often the first clue.
Is a running toilet the same as a hidden leak?
A toilet leak shows on the bill and the meter too, but it drains into the sewer and does not wet the structure. Check toilets with a few drops of food coloring in the tank before assuming a slab leak.
What happens to the floor after a slab leak is fixed?
Wet carpet pad, laminate or tile setting materials often come up so the slab surface and the bottom plates can dry. The drying team verifies with readings before any new flooring goes down.
Does homeowners insurance cover slab leaks?
Many Texas policies cover the resulting water damage and sometimes the access to reach the pipe, but not always the pipe repair itself. Coverage depends on your policy, so it is worth checking with your own insurer.
Water in a Cedar Park home? Start the dry-out now.
Water that reaches the slab and the bottom plates is the hardest part of a house to dry. The drying team extracts first, sets equipment to the load and keeps it running until the meters agree.